
Part Number:
(LZR)
WEDCLMP3046
Product Details:
5/8" W x 4−7/8" L x 0.96" −to− 1.13" H No hardware included Aluminum wedges when tightened cause the height of the device to increase (similar to a wedge jack). Used to brace inner laser assembly to the housing. Center hole allows piece of allthread and nuts to squeeze wedges together.
Minimum and maximum height measured using 0.1" diameter rod, or included hardware. Some wedge shafts are threaded 1/4−20. All shafts 0.2" diameter.
Part #: PS PP-1659A/G
Description: This Battery Charger is in like NEW condition! Th…
Brand: Syncor Industries Corp.
Part #: HWX 8947-401
Description: Illinois keyed latch. Mechanical. Fits 7/8" hole.…
Brand: Illinois
$10.00 / Each
Part #: RWF TS1A5230
Description: 5230 ohm 1% 1w "RS1A" Wire Wound Resistor NOTE: …
$0.75 / Each
Part #: PUB HP-330B/672
Description: HP 330B Distortion Analyzer Serial 672 & Above Op…
$22.00 / Each
Part #: PUB ANR-MS610A
Description: Anritsu MS610A Spectrum Analyzer Service Manual
$85.00 / Each
Part #: CFE 000047R00FAO
Description: 47 µF 16v Nichicon Radial Electrolytic Capacitor …
$0.30 / Each
Part #: CSM 000100R00KGA
Description: 100 pF 10% 500v Molded Mica Axial Capacitor NOTE:…
$0.36 / Each
Part #: RWF RS2C-830
Description: 830 ohm 1% 3w Wire Wound Resistor With tab termin…
$1.35 / Each