
Part Number:
(LZR)
WEDCLMP6000
Product Details:
2" W x 3" L x 0.4" −to− 0.54" H Threaded shaft and nuts included Aluminum wedges when tightened cause the height of the device to increase (similar to a wedge jack). Used to brace inner laser assembly to the housing. Center hole allows piece of allthread and nuts to squeeze wedges together.
Minimum and maximum height measured using 0.1" diameter rod, or included hardware. Some wedge shafts are threaded 1/4−20. All shafts 0.2" diameter.
Part #: PS PP-1659A/G
Description: This Battery Charger is in like NEW condition! Th…
Brand: Syncor Industries Corp.
Part #: IRF BW-3001
Description: Barker & Williamson Standard Coil Stock 18 ga 0.1…
$15.00 / Each
Part #: RWF 5SX-2500
Description: 2500 ohm 5% 5w Wire Wound Resistor With tab termi…
$1.50 / Each
Part #: TUA SA-9
Description: Hickok socket saver. 9 pin miniature.
Brand: Hickok
Part #: RWF ERH50-7.87
Description: 7.87 ohm 1% 30w Aluminum Body Resistor Has built−…
$5.95 / Each
Part #: RF 535-MN/FN
Description: Weinschel RF load 2 piece set. 1 of each: 535-MN,…
Brand: Weinschel
$35.00 / Each
Part #: ATO 77-4051
Description: Weber 32 ICA, ICEV Carburetor Tune−up Kit
$20.00 / Each
Part #: CFP 030000AACA
Description: 0.030 µF 100vdc 2% 30ppm Gudeman Corp. Polystyren…
$11.00 / Each