
Part Number:
(LZR)
WEDCLMP3000
Product Details:
3/4" W x 4" L x 0.7" −to− 0.875" H Rounded top / bottom, no hardware included Aluminum wedges when tightened cause the height of the device to increase (similar to a wedge jack). Used to brace inner laser assembly to the housing. Center hole allows piece of allthread and nuts to squeeze wedges together.
Minimum and maximum height measured using 0.1" diameter rod, or included hardware. Some wedge shafts are threaded 1/4−20. All shafts 0.2" diameter.
Part #: PS PP-1659A/G
Description: This Battery Charger is in like NEW condition! Th…
Brand: Syncor Industries Corp.
Part #: TUR 6Z10/6J10-GE
Description: 6Z10 / 6J10, GE, Compactron For a $6 up charge ($…
$6.00 / Each
Part #: CRF 1004-1511-999
Description: AEP "SMC" bulkhead jack. 50 ohm, 10 GHz. Male pin…
Brand: AEP
$5.00 / Each
Part #: TP 30488
Description: SOLA constant voltage filament transformer. New-v…
$10.00 / Each
Part #: RWF DFR-47-048
Description: 470 ohm 2% 10w Wire Wound Resistor With tab termi…
$1.75 / Each
Part #: RF 600965003
Description: EMC Chip Stripline AttenuatorsDC − 12 GHz / 1/2 w…
$6.00 / Each
Part #: CMS AN3106E-16-11
Description: Cannon 2 pin circular connectors. Matched set. Bo…
Brand: Cannon
$39.95 / Each
Part #: SIC ADO47/12
Description: Intech, very large OP amp, similar in characteris…
Brand: Intech
$9.00 / Each