Digital Selective Call Unit

Digital Selective Call Unit (EQP) SR-809

Digital Selective Call Unit

Part Number:
(EQP) SR-809

Product Details:
The Selective Call Unit is an encoder / decoder designed for operation with radio communication networks. The unit encodes signals for paging individual stations or the entire network. The unit also decodes incoming signals to determine if the station is being called. The unit is also equipped to alert the operator to incoming calls, display the calling station's ID code, acknowledge the receipt of a valid code and provide the calling station a verification code. The unit can interface to land line or radio links.

This unit may be used for protected access to remote control receivers for repeaters or remote base stations. It can also be used as a selection control encoder for multiple receive locations.

Up to 256 Unit IDs may be programmed. The Sending Unit ID is preset on an internal circuit board. The Called Unit ID is selected by front panel thumbwheel switches. Upon receipt of a valid call the ID of the calling unit is displayed on the front panel LED display, an internal buzzer sounds, a dry contact closure is available on the rear panel and the "CALL" LED lights. At this point an automatic response confirming receipt of the call may be sent out on the control link to the originating station. An internal jumper may be set so that the response is only sent when the "CALL BACK" button on the front panel is manually pushed. The units are designed to be reset after a call only by use of the manual front panel push-button switch. The reset is accomplished by momentarily grounding the reset line.

The dry contact closure may be set by internal jumper to "timed" or latch mode. In latch mode an external 'reset' pulse would be necessary to release the relay. This could be implemented by a special code sent to the repeater controller that causes the 'reset' pulse to be sent to the Selcal unit, thereby un-latching the relay. An alternative is to use the timed mode of the relay to start a timer which allows audio (with control tones) to get to the repeater controller and upon timeout the line is disconnected and the reset code is sent back to the selcal.

Selcal units operate from 120 / 230 vac or 12 vdc at 1 amp. Requires HP style AC cord with 3 round pins or coaxial connector for DC operation. Internal switch and jumpers select input power requirements.

Size 5-1/2" x 19" x 14" deep (rack mount). Rack mount frame may be removed to make unit 5-1/2" x 8 1/2" x 14". Internal plug-in cards are accessed by releasing the screw latch and swinging open the hinged, front panel door.

Complete manual for the unit is included with each order.


Complete manual for the unit is included with each order
Size 5-1/2" x 19" x 14" deep (rack mount)
Internal switch and jumpers select input power requirements
Requires HP style AC cord with 3 round pins or coaxial connector for DC operation
Selcal units operate from 120 / 230 vac or 12 vdc at 1 amp
Encoder / decoder designed for operation with radio communication networks
The unit can interface to land line or radio links
Scientific Radio Systems SR-809

Share this page

$125.00 / Each
$100.00 / 2 Each

Qty

Ground Shipping Promotion on Orders over $100

Other Categories

Scientific Radio Systems

Related Products

None

Syncor Military Battery Charger

Part #: PS PP-1659A/G

Description: This Battery Charger is in like NEW condition! Th…

Brand: Syncor Industries Corp.

Sold out
None

2.5mm Molded Plug on 5-1/2 Foot Stranded Wire

Part #: WAA 2.5MMM5.5FT

Description: 2.5mm plug on the end of a 5-1/2 foot, 2 conducto…

$1.85 / Each

HP Multimeter (MTR) 1120-1577

HP Multimeter
100 µADC

Part #: MTR 1120-1577

Description: HP Multimeter FS=100µADC. 3 3/4"W x 3 3/16"H x 1 …

Brand: HP Multimeter

$150.00 / Each

Sample Metal Oxide, Carbon Film Resistor

274k ohm 1% − Resistor

Part #: RMF 00274000R0FE

Description: 274k ohm 1% − RNC60H 50ppm Metal Film Resistor N…

$0.21 / Each

Featured Products

Spring Lock Binding Post (BP) 2804-103

Spring Lock Binding Post

Part #: BP 2804-103

Description: Abbatron spring lock binding post. 15 amp. Black …

Brand: Abbatron

$4.95 / Each

cornell dubilier oil capacitor

10 µF − 600 vdc Oil Capacitor

Part #: CFO 0010R000.6.B

Description: 10 µF @ 600 vdc 10% Oil cap. Various brands avail…

$25.00 / Each

None

Schottky Barrier Diode

Part #: SDI D4001-99

Description: Schottky Barrier Diode

$8.00 / Each

None

Standoff Terminal - Threaded Base / PTFE / Terminal Post

Part #: TSL T60

Description: Standoff Terminal - Threaded Base / PTFE / Termin…

$1.25 / Each