Product Details:
16-7/16"L x 2-15/16" sq with a 2.20" radius bore through the center. Two pieces of alumina are wedged together to form what appears to be a 1/4" diameter discharge area. Not sure if any point of the alumina provides an electrode path - i.e. an embedded electrode - or if the discharge is great enough to pass through the thin walls at the top and bottom of the alumina walls. The chamber is sealed off with plexiglass end walls. Unknown vacuum / gas status. The device must have been successful because "patent pending" is hand written on the side - most likely by Peter himself.

We're going to include 2 end walls which have a round bore o-ring seal groove on the rear and ports that appear to line up with the center of the discharge area. One end cap will accept (LZR) ENDCAP-7, the other one has threaded bolt holes that do not match any other end caps we have.

Product PDFs:
None